herve leger long sleeve dress- short

00 working code
02 working code
11 machines out of paper
12 machine door is not closed
13 machine jams
14 machine does not detect The toner cartridge
16 machines lack
17 machine is not loaded under the paper tray
41 machine size or direction and use the computer does not use paper.
42 I / F: 2 ERRORInterface problem: CENTRO * (parallel) RS232 (serial)
5F-50 machine fuser fuser is damaged or there is no voltage.
5F-50 Service CTL SFT EE fuser may be condensation, caused by moisture or temperature protection Short circuit protection. Canon LBP-730 Fuser more out of this code, temperature control system design or component defects, unstable supra skytop muska!
5F-51 does not detect the laser beam, the laser deflection motor may be damaged or cartridge not installed.
5F-51 Service CTL SFT EE abnormal motor speed laser deflection, the bearing may be too short of oil or rust, caused by excessive friction, the speed slows down.
5F-52 SERVICE M2-0212, Main motor adverse action, it is estimated the motor drive circuit itself is the problem or faulty components, especially electrolytic capacitors.
5F-54/55 machine both sides of the exhaust fan failure herve leger long sleeve dress, stopped or dead.
5F-55 SERVICE 010 possible fault locations: DC controller, formatter, main motor - do not print engine communicates with the motherboard.
5F-55 SERVICE 030-032 030 may be ranked the problem or paper drive motor switch problem.
5F-56 bypass trust touch switch.
98 - count of cartridge life is about to expire.
9A MP ILL hand to send the board to put the paper size or orientation is inconsistent with the selected computer.
1G K TONER LOW machine does not detect the black toner.
99 ITB WARNING This code means that the transfer component to life.
EF DRUM CHECK code that cartridge life to count chips.
EE DENSITY ERROR means
E0 Drum Warning This code, when only the life of the drum will remind you to.
40 LINE ERROR checking steps: 1, Check Print cable connections, check the print line connections; 2, Check the RS-232 (serial) parameters match thecomputer, check whether the RS-232 serial port parameters to match with the computer, check whether the printer port open, short, and so on.
5F-4F SERVICE CTL SFT E E estimated laser beam (laser beam) of the problem supras for cheap, but also to be verified. Power initialization, observe whether the red light on the drum.